Its great to see another Edgetracker 365 launching recently. This time from Phil who lives down in Tasmania.
He writes:
Hi Guys,
Finally it's all come together. After months of delays for motor, trailer , other bits and pieces, as well as a new motor failure and another delay for the warranty claim and replacement, the boat was finally splashed today.
Must admit that there were a few nerves at the splash today but once we passed the spot where the first motor failed and we were still going, it soon became apparent that we had a boat that was going to be a good one.
I couldn't run the new motor too hard today because it is still in the break-in period, so for most of the hour's trip we were taking it easy. Even so it was up on to the plane very easily and the 30 Merc revved very freely and we touched 24 knots a couple of times (for a very short time).
So at this stage, the motor is still running in, with two adults on board, 35 litres of fuel, all safety gear, anchor, chain & rope, tool kit battery etc., we still made 25 kts with the 4 blade prop supplied with the motor. All in all, a pretty impressive start.
Just goes to show how good Mark's designs are, also considering that I've added a small console with forward steering, and an under floor fuel tank (after discussions with Mark at the start of the build).
So thanks Mark and the advice and support from you fellow builders on the forum over the last year.
Looking forward the upcoming hours of fun and fish. Here's a few photos of the splash.
Cheers Phil
Hi Mark and fellow builders,
No comments:
Post a Comment